Apply a dot of Gel Adhesive to the circled target area of the pre-buffed underside of the artificial nail tip that will meet the natural nail.

Gently press the nail tip on the natural nail starting from the cuticle area to the free edge with constant, firm pressure, making sure to remove any air bubbles.

While gently pressing the nail tip with your other hand, place your fingernail on the LED Lamp motion sensor to flash cure for 5-7 seconds.

Finish cure for an additional 1-2 minutes to make sure sides and edges are fully cured.

Repeat steps 1-4 on all ten nails.

GEL ADHESIVE: Bis-HEA PPG-6 Glyceryl Ether/SMDI Copolymer, HEMA, Isobornyl Acrylate, Trimethylbenzoyl Diphenylphosphine Oxide – Made in Korea; 

PRE PAD: Isopropyl Alcohol, Water (Aqua, Eau) – Made in China; 
TIPS: PMMA plastic – Made in China; 

LED LAMP – Made in China

Avoid inhalation, ingestion, or prolonged contact with skin. Avoid contact with eyes

IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do so.

IF ON SKIN: Wash with plenty of soap and water then gently peel apart. Seek medical attention

Read directions for use carefully
Keep out of reach of children
Discontinue use if irritation occurs
Do not use if nail or surrounding skin is damaged or inflamed